phone
+91- 9848086926
email
info@rccchimney.com

We are the top RCC Chimneys construction company in south India.

Building things with high quality, performance.

Implementing the most advanced methodologies

About RCC Chimney

A chimney is not the complete solution to the problem of pollution control, A chimney achieves simultaneously in reduction in concentration of a number of pollutants (for exanmple co, co2, so2, so3, ash etc).

RCC Chimneys are in variably lined primarily to protect concrete and reinforcement against thermal and chemical attack from the flue gases. And thereby they (RCC chimney) remain buoyant (draft maintained) And aid plum raise (to disperse pollutants very far away) so that the RCC chimney (monolithic) will be permanent structure. The inner lining usually will be with Refractory Bricks of IS-6 /IS -8 quality (as per the chimney temperatures).

Now a day’s Pollution control board insisting to install wet scrubbers (which can be designed and supplied by us including FD, ID, fans , MDC (mechanical dust collectors of any capacity) If you use sulphur contained fuels, flue gases contains s02 and also installed wet scrubbers etc. so2 will become s03, by taking moisture from the flue gases. Due to water spray in the wet scrubbers and there by spoil the refractory lining as well as chimney also in a short period, so that better Acid Resistant Lining with suitable AR mortars, where the flue gas temperature will come down to 140 c and rest of the chimney lining can be fire brick where they will be higher than 140 c. RCC chimney cannot be a permanent structure without lining Air-gap /vent in between RCC and lining to increase the chimney life(specially for high pressure Boilers).

RCC Chimneys cannot be a permanent structure without lining Air-gap /vent in between RCC and lining to increase the chimney life(specially for high pressure Boilers).

As far as our knowledge goes none of a chimney have been constructed of modular type in the world in any industry, unless the size of the chimney is too small Domestic chimney’s can be erected with external support.

All chimneys for industries always should be self supported. Otherwise it is not only dangerous to the company but also to the outsiders nearby. Because all chimney’s should be able to with stand seismic forces of +200 km/hr wind pressure .In addition to the maximum self weight of the chimney in any Natural calamities .Already we have been observing that Heavy current poles(MS also) and cell towers which were strongly built were twisted away collapsed with heavy loss to the Govt and private Industries.

Even RCC Chimneys with continuous reinforcement can also be designed cost effectively . The investment should not be false economy. It is not only personal loss and also national loss, if anything goes wrong in long run.

RCC Chimneys Environmentally friendly chimney means strong enough to with stand strong weather condition, maintance free and cost effective.

Our Services

We are the top construction company of RCC Chimneys in South india, based out of Andhra Pradesh. Apart from Construction of RCC Chimneys we are also specialist in constructing and providing services in Boilers, Furnace, Thermo Pac. We also provide services like maintenance of Chimneys, Boilers, Furnace, Thermo Pac. We have successfully completed many projets in many state of India. We research, evaluate and plan for all the factors that will affect design and construction. We are top-listed as one amongst the best industrial Chimney Manufacturer in Andhra Pradesh, India. We can provide Air-gap in between lining and RCC with vents to protect the RCC chimney for particular cases. We can provide plat forms at different heights for pollution check, warning lights and maintenance of the chimney. We are experts in construction of RCC Chimneys for the following industires

  • Chemical, Drugs & pharmaceutical industries
  • Rubber & Paper industries
  • Plywood / lamination & sizing industries
  • Carbon manufacturing & Smelting industries
  • Food processing (rice, tea, oil, diary, etc)
  • Ceramic industries
  • Textile processing
  • Distilleries
  • Poultries
  • Power generation plants

Our Research

R.C.C. Chimney (Monolithic) Pre Cast Chimney/Modular Chimney M.S. Fabricted Chimney
  • Included Foundation work

  • 50 Plus life time, even Flue gases can be discharged at a temperature of minimum 60°C and below. It means you are saving more fuel. Fire Bricks lining included.

  • Can withstand for any weather conditions & winds. This type of chimney is a Permanent structure.


  • Maintenance Free.

  • Stay wires or no external support is required.

  • AS per Pollution control Boards instruction RCC Plat forms should be constructed.

  • Air- Gap is possible only in RCC chimney’s.

  • There is no Height limitations (suitable for small bread owen to mega power plants also).

  • Civil foundation work should be done separately.


  • No, Time period. As there is no refractory (Fire Bricks) lining, all are separate pieces. No proper jointing between each and every part.

  • Cannot withstand for extreme weather conditions & winds

  • Maintenance : Painting should be made for every 2 Yrs. (which is expensive & in - convenience) to avoid rust.

  • Outside Structure must be provided. It is not at all Permanent Chimney (temporary chimney).

  • Not possible with these chimney’s.

  • Not at all possible.

  • There is height and diameter limitation.
  • Civil foundation work should be done separately.

  • No time period. Discharging of Flue gas at 160°C temperature is mandatory, Otherwise Flue gas temperature converted to SO3 which damages the chimney. So you are loosing 100°C temperature and prestigious fuel. At the time of replacing the Chimney it will be expensive, production loss and require more space for replacement.

  • Cannot withstand for extreme weather conditions & winds


  • Maintenance : Painting should be made for every 2 Yrs. (which is expensive & in - convenience) to avoid rust.

  • Stay Wires must be provided with ordinary Fabricated chimney.

  • Not possible with these chimney’s.

  • Not at all possible.

  • There is height and diameter limitation.